P.O. Box 6259,  Spring Hill,  FL 34611 
Fax:  352 666 4141 

Prowler Stainless Steel Polished Dash Gage Trim Set©

PART#  ACC-PRGT905  

INSTALLATION INSTRUCTIONS

Included:  4- Dash Gage Trim Rings (1 large and 4 medium),
1- Tachometer Trim Ring, 1- Large Dash Gage chrome vinyl Sleeve Insert,  Adhesive promoter pen,
4- Small Dash Gage chrome vinyl Sleeve Inserts, 5- Circle stickers with black edge.    

 
1.  Take your Trim Rings out of the wrapper.  Do not remove the back red tape covering.
 
2.  Wash Center Dash Gage Rings and your Tachometer with soap and water.  Rise thoroughly and dry.

3. Take your sheet of circle stickers and peel off a small one. You are going to mount this sticker on top of the glass of each of your gages and tach gage.  You have to be very careful to center the sticker. Once you have positioned into place press down on the center and work your way out to the edges.
Once the sticker is flat on the glass (don’t worry if part of the sticker is up on the side the dash itself) peel off the clear protective sheet.  What will be left is the black trim sticker.

NOTE:  These stickers are optional. Your metal Dash rings are slightly smaller than your gages, so not to damage your dash when mounting them.  The black sticker trim rings hide the tiny amount of glass the metal rings leave exposed on the outside diameter. 

4.  Take a Trim Ring for one of the five Dash Gage dials and put it up to glass gage. Position it as you want to permanently mount it.  Once you are comfortable with exactly how it will fit you may take the red backing off the back side exposing the sticky tape.

5.  Take your promoter pen and wipe the perimeter of your gage glass where the Trim Ring is going to attach. 
NOTE: If you used the Sticker option do not use the promoter on top of the stickers.

6.  Very carefully re-position the Trim Ring in place lightly touching it the perimeter of the gage glass circle.  Make any final tiny adjustments.  Once you are certain that is where you want it Trim Ring push firmly along the entire ring to seat it in place. 

7.  You may even want to stick pieces of masking tape over the Trim Ring attaching it tightly to the gage glass.  Leave it overnight for a tight fit. Then remove the masking tape. Clean the area with rubbing alcohol.

8.  Install the remaining four dash Trim Rings and on tachometer Trim Ring as explained above.

9.  Now remove the five vinyl chrome Sleeves from their wrapper.  There should be one large one for the center dash gage and four smaller ones for the four outer dash gages.

1 of  5