P.O. Box 6259,  Spring Hill,  FL 34611 
Fax:  352 666 4141
 

Engine Dress-Up Trim Kit
Part # IH-PSI050

 

Included in this kit.
2 -- Long Strips for Front engine compartment support bar Chrome Vinyl Covers
1 -- Drivers side Rear Support Bar Chrome Vinyl Cover
1 -- Passenger side Rear Support Bar Chrome Vinyl Cover  
2 -- Engine Manifold ‘Stainless Steel’ Top of Manifold Strips

1.  First thoroughly clean the areas to be covered.  Use soap and water.  Next wipe thoroughly with Rubbing Alcohol and then let dry. 

2.  It is best to take each piece before you peel the protective back off of it and position
it on the engine where it is supposed to go. Consider this your practice run.
Note: Once you stick the pieces on it will impossible to use them again.
Once you are comfortable on how it will fit move to the next step.

3.  After you have centered each foil piece long ways on TOP of its proper support bar (to be covered) as a practice run:  Pick a Chrome vinyl piece and Peel off the backing on the strip. 
Once again center the foil strip on top the bar as did before during the practice run.
Carefully push down with one finger along length of the foil on top of the bar.
The foil strip should now be laying flat on top the bar and centered long ways and side ways.
The idea here is when you are done you want the seam to end up underneath the bar so it is not visible.  See Figure A below.

                                   
            Figure A                                   Figure B

Start with one side. Run your finger long ways evenly pressing the foil strip down around the bar.  See Figure B above.
Do the same for the other side. 

When completed the seam should be along the center line of the bottom of the bar. 
See pictures on Page 2.

Page 1 of 2