P.O. Box 6259,  Spring Hill,  FL 34611 
Fax:  352 666 4141 

PROWLER 3pc Stainless Steel Dash Bezels©

PART#  ACC-PRMT903  (Polished)
INSTALLATION INSTRUCTIONS

 

      Parts included:    

       2- Polished Circular Trim Rings, 1- Elongated Center Trim Ring, Adhesive Promoter Pen
 
 NOTE:  Do not remove the clear plastic film on top of the trim rings or the red liner on the backside of the trim rings until instructed to do so.

 

  1. Clean top of dash area thoroughly with soap and water to remove any dirt.  Once dry, wipe thoroughly around each of the three vent grilles with household Isopropyl Alcohol. Let dry.

 

  1. Take the center Elongated Trim Ring and set it on top of the dash center vent.  Slide it around until you see how it fits into position.  The idea here is for you to become familiar with its proper placement. 
    NOTE:  Once you attach the Trim Ring you will not be able to move it again.

 

  1. Once you are satisfied with the fit - remove the red liner from the attachment tape on the underside of the Trim Ring. Very carefully hold the Cover over the Center Vent on top the dash.  When you are certain it is in the correct position - Press down firmly to set.  Push firmly along the entire perimeter edge to ensure a tight bond.  It is a good idea to place several pieces of masking tape to hold down the Trim Ring while it is setting.  It is best to let it set for 8 hours.  Do not get it wet during this time.

 

  1. After the Trim Ring is set, remove the masking tape; remove the clear liner on the front of the Trim Ring.  Clean area around the Trim Ring of any remaining residue.

 

  1. For the remaining two Circular Trim Rings repeat steps 1 through 4.
     

CARE AND MAINTENANCE:  Care must be taken when cleaning your cover. It is a good idea to lightly dust your cover with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

      



TheProwlerStore.com a HotCarAccessories.com website a division of emagineit, Inc.
Copyright 2005-2008