P.O. Box 6259,  Spring Hill,  FL 34611 
Fax:  352 666 4141 

PROWLER 3rd Brake Light Trim with Chrysler Wing Emblem, 2pc©

PART#  ACC-PRBL304-1

INSTALLATION INSTRUCTIONS

 

      Parts included:                                                   

       1- 3rd Brake Light Trim Ring, Tiny Chrysler Wing Emblem, 1-Adhesive Promoter Packet
 

1.  Take your Trim Ring Bezel out of the wrapper.  NOTE: Do not remove the back red tape covering until instructed to do so.

 2.  Wash your 3rd Brake light with soap and water.  Rise thoroughly and dry.  Now wipe it down with rubbing alcohol to remove any oil residue.

 3.  Take your Bezel trim and without removing the backing hold it up to your 3rd Brake light. Position it as you want to permanently mount it.  You might want to slightly bend the ends in to match the slight bend in your cars lens assembly.  You can do this by trial and error.  Once you are comfortable with exactly how it will fit move to the next step.  exposing the sticky tape.

 4.  Take your promoter pen and wipe the perimeter of your 3rd brake light where the trim bezel is going to attach.

 

5.  You may now take the red backing off the back side of your trim piece.  Very carefully re-position the Trim Bezel in place without touching it against the 3rd Brake light. 
Once you are certain that is where you want it lightly set it on the 3rd brake light while still holding it. Make any final tiny adjustments.  Once this is done, press on the bezel to secure it against the 3rd brake light.  With your fingers - press all the way around the bezel to ensure it is sticking to the 3rd brake light on all sides.

 6.  Now take the small Chrysler Wing emblem and hold it in the center of your 3rd Brake Light.  Once you are comfortable to where you want it to mount then remove the backing to expose the sticker under side.  Hold it up to the 3rd Brake Light and lightly set it to where you want it to mount.  Make any final adjustments.  Press down along the entire wing enblem to secure it to the lens cover.    


7.  You may even want to stick pieces of masking tape over the bezel attaching it tightly to the 3rd brake light housing.  Leave it overnight for a tight fit. Then remove the masking tape. Clean the area with rubbing alcohol. 

 

TheProwlerStore.com a HotCarAccessories.com website a division of emagineit, Inc.
Copyright 2005-2008